Frequently Asked Questions
It's actually quite easy! Most end cap bearings are held in by small retainer clip removed with a small flat screwdriver. Spool Shaft bearings are generally held in by a small spool pin. Most are easily removed with channel locks, pin pliers or pin pulling tools. Use care as not to gouge or bend the pin. The pins are always removed by pushing on the thin tapered end, outward. Reverse procedure for re-installation.
Most bait casting reels use a 3x10 x4 bearing on the end caps. Most spool shaft bearings are 5x11x4. Not all reels have a spool shaft bearing. You can easily check by removing the spool and inspecting. Our 3-Pack will fit 90% of all bait casting reels. Most Shimano's will utilize two 3x10x4 bearings. Most Daiwa reels are a combination of the above and some Daiwa such as the Tatula will require a 3x8x4. A bit of internet research will provide you with all the sizing info you need. Note: Spool Speed has much knowledge about sizing and we have literature on hand providing fitment. However, due to frequent product and model year changes, Spool Speed Bearings cannot be responsible for shipping when replacing wrongly ordered sizing. Though infrequent, sometimes even the sizing literature is incorrect. Spool speed is always eager to correct and exchange any wrong size bearing but WILL NOT BE RESPONSIBLE FOR SHIPPING EXCHANGES. We are an extremely friendly and accommodating company. We will even ask you to send pictures of your bearing on hard to fit applications. We are always eager to help. One thing we have learned: Every bearing company on the internet who lists bearing sizes, always contain incorrect information in some applications. We like to get it right and we are always available to call or text your sizing questions. * (803) 513-0731* Clear pictures prove to be most helpful in unusual or older reels.
Actually, it's quite the opposite! Initial spool start up inertia is lower with lightweight ceramic bearings allowing spool to start faster and with less effort! You will not tire as easily and your casting distance can improve with less effort. Individual results will vary. Your experience with a bait caster, your brake settings and spool shaft end cap tension are all factors. Once you learn to operate your bait casting reel with less backlash controls, you'll get increased distance and less effort from Spool Speed Bearings.
We do not use oil unless you need either less noise or you wish to perform our performance secret listed on the Spool Speed Ceramic lube product page. Read it! It's awesome! It's worth the time! You want to know why our videos on Instagram spin longer than yours? We Hope you read this!
We do not. If you use them, just push them on sandwiched between your fingers with color side out (remove with a needle). The choice is yours. Maybe in a saltwater environment, but not in fresh! Enough said! Your choice.